Butch Bussen

Yep, I agree. How quickly some people judge. I got my novice in 1961, never got on the air, got my general in 1968, now an extra. I'm totally blind, and I just can't solder that small stuff. I'm glad to pay someone else to do such things.
Node 3148
Wallace, ks.

On Sun, 3 Jun 2018, John Rickert wrote:

Hmmmmmmmmmmm. Not sure if your comment was meant to irritate. I am almost
80, have designed homing systems for torpedoes and built way more bread
board projects than most. I just want a cable and am willing to pay for
it. I don't think there is any shame in that.

Thanks, John

On Sun, Jun 3, 2018 at 2:28 PM Teton Amateur Radio Repeater Association
(TARRA) <> wrote:

So much for a ham radio operator if you can't make up a couple of simple

I know a lot of people use some of the Alinco mobiles and other ham
radios, I wouldn't use one for the kind of continuous duty you would have
for this kind of operation.

Mick - W7CAT
Node 3464

----- Original Message -----
From: "k9dc"
Sent: Sunday, June 03, 2018 01:56:30 PM
Subject: Re: [IRLP] No OUTPUT to IRLP

Most folks make up their own cable (it is pretty easy as cables go). The
IRLP connector pin out is covered in the Documentation, and on the wiki

Further, there several sample radios with cabling shown on the main web
site, Look at link on the left “Node Radios”


On Jun 3, 2018, at 11:43, John Rickert wrote:

I am getting ready to put together my own IRLP node. I have a general
knowledge of what is needed but it sure would helpful if someone put up a
schematic drawing or all the components and how they hook together.

It also would be very helpful to see suggestions of a radio that works
best, where to get the software and how the radio connects to the computer.

I apologize if this exists but I can't seem to find it. I have seen
the schematic on Daves site but it's very confusing.

Many thanks, John


Be sure to check out all the latest at our web site
<>! <>

Join to automatically receive all group messages.