Re: New install


Teton Amateur Radio Repeater Association (TARRA)
 

I would like to know exactly what connections you are using on the radio and on the IRLP board and what is connected to what. It shouldn't be complicated.

Keep in mind it doesn't matter what is connected to pin 8 if there isn't a shorting plug in the microphone connector.

Mick - W7CAT
Node 3464

----- Original Message -----
From: Darin Lehnert
To: IRLP@irlp.groups.io
Sent: Saturday, December 21, 2019 02:11:59 PM
Subject: Re: [IRLP] New install

> Hi William,
> Is this a 8 channel 16 channel Motorola ? If it is a 16 channel you need to
> program
> pin 8 on the Motorola to Select PL/DPL & CSQ Detect and active low
> You also need to make sure your active low on the IRLP board
> and I always use a 10k resistor on the pink side of the sound fob.
>
> Good Luck !!
>
> Darin
> kc7tig
>
> On Sat, Dec 21, 2019 at 12:44 PM William Phillips
> wrote:
>
> > Would the audio be a separate issue? Could this be a software issue should
> > I try reinstalling?
> > > On Dec 21, 2019, at 11:28 AM, Nosey Nick VA3NNW
> > wrote:
> > >
> > > William Phillips wrote:
> > >> Pressed : Seen
> > >> 1:nothing
> > >> 2:3 when released 1
> > >> 3:3 when released 1
> > >> 4:5 when released 1
> > >> 5:5 when released 1
> > >> 6:7 when released 1
> > >> 7:7 when released 1
> > >> 8:9 when released 1
> > >> 9:9 when released 1
> > >
> > > Sounds a lot like DTMF 1 is stuck "high", and adding 1 to otherwise-even
> > > numbers.
> > >
> > > Check (I think) D0 / GPIO 4 / Pin 15 for possible shorts?
> > >
> > > Nick
> > >
> > > --
> > > "Nosey" Nick Waterman, VA3NNW/G7RZQ, K2 #5209.
> > > use Std::Disclaimer; sig@...
> > > I checked the Internet to see how long a possum can hold its breath.
> > >
> > >
> > >
> > >
> > >
> >
> >
> >
> >
>
>
>
>
--

Join IRLP@irlp.groups.io to automatically receive all group messages.