Re: New install


Teton Amateur Radio Repeater Association (TARRA)
 

There doesn't need to be, all that is being done is the "on hook" of the microphone is being grounded through the microphone cable. I have taken several microphones and jumpered a wire internally to take care of it. A shorting plug is just connecting pins 3 & 4 of the microphone connector.

Mick - W7CAT
Node 3464

----- Original Message -----
From: John
To: IRLP
Sent: Saturday, December 21, 2019 09:27:27 PM
Subject: Re: [IRLP] New install

> William
> a silly question perhaps,
> but if the mic needs to be attached to a 'hangup plate' is said plate earthed to
> radio chassis?
>
> John @ 6163
>
> > On 22/12/2019 12:26:47 PM, William Phillips (bphillips.nnh@...) wrote:
> > > The radio connections are as follows
> >
> > Radio Irlp board
> > Pin 2 9
> > Pin 3. 2
> > Pin 7. 6
> > Pin 8. 7
> > Pin 11. 8
> >
> > I have a 10uf capacitor on pin 9 irlp to pin 2 radio. I have radio programmed for cos pin 8 active low and the board matches. I tried another radio I have same issue. I also confirmed this radio works with signalink on an EchoLink I had set up. I have a mike connected with the hangup plate attached.
> > > On Dec 21, 2019, at 6:11 PM, Teton Amateur Radio Repeater Association (TARRA) wrote:
> > >
> > > I would like to know exactly what connections you are using on the radio and on the IRLP board and what is connected to what. It shouldn't be complicated.
> > >
> > > Keep in mind it doesn't matter what is connected to pin 8 if there isn't a shorting plug in the microphone connector.
> > >
> > > Mick - W7CAT
> > > Node 3464
> > >
> > > ----- Original Message -----
> > > From: Darin Lehnert
> > > To: IRLP@irlp.groups.io
> > > Sent: Saturday, December 21, 2019 02:11:59 PM
> > > Subject: Re: [IRLP] New install
> > >
> > > > Hi William,
> > > > Is this a 8 channel 16
>
>
>
>
--

Join IRLP@irlp.groups.io to automatically receive all group messages.