Re: PiRLP Suddenly Not Working

Russ Woodman
 

Hi, Dave.

I am 100% sure the cable is connected correctly. It would appear that the problem is on the IRLP board, not the Pi. I say this because if I leave the ribbon cable connected and unsolder the 3.3v jumper mod on the IRLP board, the Pi will boot fine. If I solder it back up again, Pi doesn't boot. Is there someplace I can look on the IRLP board for a short or cold solder or something? This was work in its exact configuration 45 minutes before I powered it on the second time.

Russ

Join IRLP@irlp.groups.io to automatically receive all group messages.