OK, I'll take a look at CON6 with a scope, be interesting to see what the amplitude is. In the meantime I can experiment with alsamixer. 73, Al

The auto gain has an "OO" in it. Second Mic setting or Capture is set to 44 at the moment. You make an interesting point about the TYT level at the connector. I guess I can put a scope on it at some p

David: I am using the TYT-9000D UHF radio for my node. The audio source comes directly from the radio main board (RX Audio) to the mic input to a SYBA USB sound adaptor to the Pi. The alsamixer MIC in

This may be a common issue but being new to IRLP I'm still fine tuning my node and learning. The issue is that when I send DTMF tones from different radios the node does not recognize the tones. I hav

David, thank you, that got it! Al

I want to thank everyone who responded to my question on node timeout. I was able to edit the file for Repeater timeout in Environment, using Putty, however when I try to save the change using ^O in N

Thank you I’ll go the route where I will leave the default time out for nodes and disable the time out for reflectors. Al

Can I get an explanation on how to disable the node time out timer in the software? My node disconnects from other nodes and reflectors after approximately thirty minutes of being idle. I understand t

That’s what I thought. Thanks, Al

Should my simplex node be sending an ID over the air even though the node is usually idle? If so how can I enable this in the software? 73, Al W6AAX stn3913

Admin, that was the key Thanks Al W6AAX

Hello: I'm a new owner and having issue whereas I can not access the control console. I have tried different computers on my network. The required ports are forwarded and I can run PUTTY from my deskt